Power factor (shooting sports)

A high-speed photography of a .38 Special bullet fired out of a Smith & Wesson Model 686 revolver.

Power Factor (PF) in practical shooting competitions refers to a ranking system used to reward cartridges with more recoil. Power factor is a measure of the momentum of the bullet (scaled product of the bullet's mass and velocity).

Power factor is used in competitions sanctioned by the International Practical Shooting Confederation (IPSC), United States Practical Shooting Association (USPSA), Bianchi Cup, Steel Challenge and International Defensive Pistol Association (IDPA).

Calculation

The power factor is based on the bullets momentum as it's moving through the air by measuring the bullet speed using a chronograph and measuring a similar bullet mass on a weighing scale, thereafter calculating the power factor by the formula:

{power\;factor}={mass}\cdot {velocity}

The power factor can be represented using different units:

The SI-unit newton seconds (kg·m/s, or simply Ns), by measuring the mass in kilogram (kg) and velocity in meter per second (m/s). Identically, by multiplying by a factor of ¹⁄₁₀₀₀ the unit gram can be used as input to the formula instead of kilogram, which is handy since bullet weights often are stated in grams by international manufacturers.

newton\,second={\frac {gram\cdot m/s}{1000}}

The imperial unit "kilo grain feet per second" (kgr·ft/s). "Grain feet per second" (gr·ft/s) can be obtained by measuring the mass in grain (gr) (7,000 to the pound) and velocity in feet per second (ft/s), but since their product yields a very large number it is common to multiply by a factor of ¹⁄₁₀₀₀, obtaining the power factor in "kilo grain feet per second" instead.

kgr\cdot ft/s={\frac {grain\cdot ft/s}{1000}}

Since by definition 1 gram = 15.4323584 grains and 1 m/s = 3.2808399 ft/s, their product is 50.6310987 and the two units can be converted back and forth using the following relationship

kgr\cdot ft/s=Ns\cdot 50.6310987

and

Ns={\frac {kgr\cdot ft/s}{50.6310987}}

Examples of different loads

Note that the table below are examples, and for the same caliber different bullet weights can be used. Bullet velocity depends amongst other on bullet weight, powder types used and barrel length for the particular firearm.

Cartridge	Bullet mass (grains)	Muzzle velocity (ft/s)	Power Factor (kgr·ft/s)	Bullet mass (gram)	Muzzle velocity (m/s)	Power Factor (newton seconds)
9x19 mm	116 gr	1,150 ft/s	133 kgr·ft/s	7.5 g	350 m/s	2.6 Ns
.40 S&W	155 gr	1,200 ft/s	186 kgr·ft/s	10 g	366 m/s	3.7 Ns
10mm	220 gr	1,250 ft/s	275 kgr·ft/s	14.3 g	381 m/s	5.5 Ns
5.56 NATO	62 gr	3,100 ft/s	192 kgr·ft/s	4 g	945 m/s	3.8 Ns
7.62 NATO	175 gr	2,590 ft/s	453 kgr·ft/s	11 g	790 m/s	8.7 Ns
12 gauge	1 ¹⁄₈ oz (492 gr)	1,200 ft/s	591 kgr·ft/s	32 g	366 m/s	11.7 Ns
12.7×99mm NATO	750 gr	2,820 ft/s	2,115 kgr·ft/s	50 g	860 m/s	43 Ns

Verifying During Competition

For all major shooting competitions, claimed power factors are checked by firing the competitor's gun and ammunition through a chronograph. The most common practice is for a competitor to provide a certain number of rounds to the Range/ Safety Officers at the beginning of the match day. During the course of the match, the Range/Safety Officers at the chronograph station will pull a bullet from the competitor's ammunition and weigh it. When the competitor arrives at the chronograph station, they provide their pistol and an empty magazine to the Range/Safety Officer who loads a number of rounds into the magazine and fires them through the chronograph to determine the ammunition's velocity. The power factor is verified against the competitor's claimed power factor. If a competitor claims major power factor and fails to achieve it, they are moved to minor and their targets are scored accordingly. If a competitor fails to make minor power factor, they generally can continue to shoot the match, but will do so for no score.

At local (often referred to as "club") matches, it is rare to verify the competitors' claimed power factor, except to ensure the minimum caliber is met (e.g., an IPSC Standard shooter using a 9 mm bullet and claiming Major power factor).

Various shooting organisations

International Practical Shooting Confederation

IPSC provides the two power factors Minor and Major which have different scoring points on paper targets. The IPSC Target has the three scoring zones A, C, and D, with the points 5-3-1 for Minor and 5-4-2 for Major. Good hits are scored equally regardless of power factor, while lesser hits are penalized less with Major power factor. The concept historically originates from the idea that a lesser hit with a harder hitting caliber will be more likely to end a firefight in a real life situation. However, modern ballistic studies have shown no noticable difference in terminal performance correlating to the recoil difference between typical minor and major handgun calibers.^[1] On the other hand, the power factor requirement has been kept to award the greater challenge of marksmanship required by competitors to shoot firearms with more recoil well.

In IPSC competitions all handguns must have a power factor of at least 125 kgr·ft/s (2.5 newton seconds), and therefore almost anything of 9x19 mm or greater caliber will meet the minimum required power factor. The minimum power factor rule is designed to mitigate the speed and accuracy advantages of smaller calibers. Less-powerful cartridges have less recoil, and therefore can be fired more quickly with the same accuracy. Setting a minimum power factor value requires recoil management skills by all competitors.

Division	Minor scoring	Major scoring
Handgun Production	125 kgr·ft/s (2.5 Ns) Only minor scoring
Handgun Standard, Classic, Revolver	125 kgr·ft/s (2.5 Ns)	170 kgr·ft/s (3.4 Ns)
Handgun Open	125 kgr·ft/s (2.5 Ns)	160 kgr·ft/s (3.2 Ns)
Rifle All divisions	150 kgr·ft/s (3 Ns)	320 kgr·ft/s (6.3 Ns)
Shotgun All divisions	480 kgr·ft/s (9.5 Ns) Only major scoring

Handgun

The desire to get the benefit of major scoring has led to the development of high speed 9 mm cartridges loaded to major, such as .38 Super. The felt recoil of a normal handgun in .38 Super is similar to the .45 ACP, but the higher pressure in the .38 Super provides more gas pressure for muzzle brakes. The .38 Super caliber got popular in the early 80's, and has continued to be popular in the Open division after its introduction in the 1993 season.

In the Open division IPSC has a lower power factor requirement of 160 kgr·ft/s for Major, while the other IPSC handgun divisions require a power factor of 170 kgr·ft/s for Major. Open and Revolver are also the only divisions that allows major scoring with a 9 mm bullet diameter (the other handgun divisions require a 10 mm bullet diameter). Together with muzzle brakes only being allowed in the Open division, this has made the .38 Super and 9x19 mm cartrdige loaded to major become a popular option in the Open division in recent years. Higher operating pressures of the cartrigdes like the 9x19 mm Major and .38 Super are preferred over for instance the .45 ACP since it provides more gases for the compensator, dampening the felt recoil and muzzle rise more. Other handgun divisions are not permitted muzzle brakes, making 9 mm Major and .38 Super uncommon outside Open and Revolver.
In the Standard division, the bullet caliber must be at least 10 mm in order to achieve major scoring, leading to less magazine capacity, and the competitor therefore has to make a choice between minor and major considering the difference in recoil, magazine capacity and points on target. It is a common belief that major scoring will give better results, but the main downside is more expensive and less available ammunition.
In the Production division extra points are not awarded for Major power factor, and thus the competition is dominated by 9x19 mm caliber loaded to minor power factor. This, amongst other reasons, is why the Production division currently is the most popular division.
In the Classic division a choice can be made between up to a 10-shot capacity 1911 with minor scoring (eg. with 9x19 mm) or up to an 8-shot capacity 1911 with major scoring (e.g. .45 ACP or .40 S&W).
In the Revolver division major scoring can be achieved with a 9 mm bullet diameter, but with a power factor of 170. A popular cartridge in revolver is the .45 ACP since it is easier to use with speed loaders. From 2017, revolvers with a capacity of 7 rounds or more will be scored with Minor power factor.

Rifle

In both the Open- and Standard rifle divisions, minor power factor is dominating due to less recoil, and 5.56x45mm/ .223 Rem is a common caliber. Ammunition loaded to major power factor such as 7.62×51 mm/ .308 Win has a bigger recoil impulse, and is regarded as having an advantage on stages with targets at long range.

Shotgun

In shotgun only a Major power factor of 480 kgr·ft/s is used throughout all divisions. 12 gauge is the most common caliber, an most handle the recoil well. The extra power of a 12 gauge gives the competitors better margins of error when it comes to hit steel targets. Although 12 gauge is most prevalent for both male and female shooters, it is also possible to use other calibers, such as the smaller 16 or 20 gauge. The smallest 20 gauge has the advantage that it is easier to carry and for the shooter to keep balance while shooting, thus making it easier to shoot more accurately. However the smaller caliber requires however more precision, especially on small steel targets.

United States Practical Shooting Association

USPSA also provide Minor and Major scoring based on power factor. Metric targets are divided into the scoring areas A, B, C and D with Minor and Major points 5-3-3-1 and 5-4-4-2 respectively, while IPSC Targets are divided into the scoring areas A, C and D with Minor and Major points 5-3-1 and 5-4-2 respectively.

In USPSA as of 2014, a value of 165 kgr·ft/s or greater is considered Major for all divisions (except Production and Carry Optics where there only is minor scoring), while values below 165 kgr·ft/s are Minor.^[2] Until a point in the late 1990s, the cut off point for "making Major" was 175 kgr·ft/s.

Division	Minor scoring	Major scoring
Handgun Production, Carry Optics,	125 kgr·ft/s (2.5 Ns) Only minor scoring
Handgun Open, Limited, Limited-10, Revolver	125 kgr·ft/s (2.5 Ns)	164 kgr·ft/s (3.3 Ns)

Steel Challenge

A minimum power factor of 120 kgr·ft/s (2.4 Ns) was previously required to activate the stop plate which stops the competitors time, but since around 2011 the stop plates are no longer connected to timers. Insted regular shot timers that register the last shot fired are used. Therefore the minimum power factor rule no longer applies, and competitors are encouraged to use low power factor ammo in order to preserve the steel targets.

International Defensive Pistol Association

The IDPA also has different power factors, and they are calculated the same way, however there is no scoring distinction as in USPSA. A particular IDPA division has a minimum power factor, and the firearm must meet or exceed this minimum to be legal for competition. The minimum power factor is 125 kgr·ft/s for all divisions, except Custom Defensive Pistol (which is restricted to semiautomatics chambered for .45 ACP), which has a power factor of 165 kgr·ft/s.^[3]

In all instances, it is up to the competitor to ensure his/her ammunition meets the requirements for the competition or equipment Division.

Effective 17 January 2011 the power factor for the stock service revolver division (SSR) was reduced to 105 kgr·ft/s since most factory produced .38 special ammunition available on the market did not meet the previous minimum power factor of 125 kgr·ft/s.^[4]

NRA Action Pistol

In the Bianchi Cup, all matches requiring the use of centerfire ammunition must meet or exceed a power factor of 120 kgr·ft/s.

References

↑ FBI Training Division Justifies 9mm Caliber Selection - The Firearm Blog
↑ "USPSA Rule Book, Appendix D1" (PDF). USPSA. Retrieved 24 June 2014.
↑ "IDPA Rule Book, Appendix One" (PDF). IDPA. Retrieved 7 April 2014.
↑ "IDPA web notice". IDPA. Retrieved 31 January 2012.

This article is issued from Wikipedia - version of the 11/7/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.