1176 Peak Limiter

The 1176LN Peak Limiter is a compressor introduced by UREI in 1968. The 1176LN was inducted into the TECnology Hall of Fame in 2008.[1] At the time of its introduction, it was the first true peak limiter with all solid-state circuitry.

Uses

Revisions

The 1176 underwent a number of revisions including the addition of Brad Plunkett's low-noise (LN) circuitry to produce the 1176LN. This reduced the noise by 6 dB and redistributed the noise spectrum, producing even more noise reduction in the sensitive mid-range. Revisions D and E are reputed to sound the best.[2]

All Button Mode

It was common to use the 1176 in 'all-button mode' or 'British mode'. This was when all four of the ratio buttons are pressed simultaneously.

"The way the 1176 sounds, and specifically, the way All-Button mode sounds, is partially due to its being a program dependent compressor. The attack and release are program dependent, as is the ratio.

The 1176 will faithfully compress or limit at the selected ratio for transients, but the ratio will always increase a bit after the transient. To what degree is once again material dependent. This is true for any of the 1176’s ratio settings, and is part of the 1176’s sound.

But in All-Button Mode, a few more things are happening; the ratio goes to somewhere between 12:1 and 20:1, and the bias points change all over the circuit. As a result, the attack and release times change. This change in attack and release times and the compression curve that results is the main contributor to the All-Button sound. This is what gives way to the trademark overdriven tone. The shape of the compression curve changes dramatically in All-Button. Where 4:1 is a gentle slope, All-Button is more like severe plateau! Furthermore, in All-Button mode there is a lag time on the attack of initial transients. This strange phenomenon might be described as a "reverse look-ahead".[3]

Reputation

Mike Shipley says “The 1176 absolutely adds a bright character to a sound, and you can set the attack so it's got a nice bite to it. I usually use them on four to one, with quite a lot of gain reduction. I like how variable the attack and release is; there's a sound on the attack and release which I don't think you can get with any other compressor. I listen for how it affects the vocal, and depending on the song I set the attack or release—faster attack if I want a bit more bite. My preference is for the black face model, the 4000 series—I think the top end is especially clean.”[4]

Jim Scott says “They have an equalizer kind of effect, adding a coloration that's bright and clear. Not only do they give you a little more impact from the compression, they also sort of clear things up; maybe a little bottom end gets squeezed out or maybe they are just sort of excitingly solid state or whatever they are. The big thing for me is the clarity, and the improvement in the top end.”[4]

See also

LA-2A Leveling Amplifier

References

This article is issued from Wikipedia - version of the 9/8/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.